How Did Shutter Dogs Get Their Name?
How do you install shutters with shutter fasteners?
Table of Contents
Enlarge each hole in the shutter with a 5/16-inch drill bit. Reposition the shutter. Insert shutter screws through the holes in the shutter and into the pilot hole. Use a Phillips screwdriver to tighten the screw and secure the shutter to the wall surface, being careful to not overtighten and avoid warping.
How do you secure a shutter?
Enlarge each hole in the shutter with a 5/16-inch drill bit. Reposition the shutter. Insert shutter screws through the holes in the shutter and into the pilot hole. Use a Phillips screwdriver to tighten the screw and secure the shutter to the wall surface, being careful to not overtighten and avoid warping.
Where do you put a shutter dog?
Regardless of mounting type, shutter dogs should be positioned towards the outer edge of the shutter, about ΒΌ of the width back (e.g., on a 16 wide shutter place the shutter dog about 4″ from the edge). They should be far enough below the shutter to allow it to swing past when the tieback is in a horizontal position.
”
What are shutter holders called?
What are shutter dogs? Also called shutter holdbacks or shutter tiebacks, shutter dogs are designed to keep your window shutters tight to the wall when open. Mounted directly below the open shutter panel, they pivot horizontally, allowing you to release and close the shutters when needed.
How do you hang shutters with shutter clips?
– Push a shutter clip partially onto the ribs at each corner of the shutter with. … – Hold the shutter against the mounting surface in the position where it will be attached. … – After the Shutter-Clips are in position and fastened to the. … – Read all of Step 4 and view Figure 4 before installing Shutter-Clips.
How are shutters attached?
Newer model shutters are mounted by hanging on a metal clip screwed into the wall. Older model vinyl shutters use a mounting clip called a shutter lok.” Shutter loks mount through existing holes in the shutter that extend to the house facing surface. Shutter loks look like long plastic nails.
”
What holds a shutter open?
What are shutter dogs? Also called shutter holdbacks or shutter tiebacks, shutter dogs are designed to keep your window shutters tight to the wall when open. Mounted directly below the open shutter panel, they pivot horizontally, allowing you to release and close the shutters when needed.
What is a pintle hinge?
A pintle is a pin or bolt, usually inserted into a gudgeon, which is used as part of a pivot or hinge. Other applications include pintle and lunette ring for towing, and pintle pins securing casters in furniture.
Where should shutter hinges be placed?
Surface mount hinges affix to the front (or in some cases the back) of exterior wooden shutters and to the face of the window frame. Correctly sized exterior shutters do not need to be altered or modified to install with surface mount hinges.